#Sandhouse Extra Durable 2 Component Top Coat - 💪OmniStrong💪

OmniStrong 2 Component Topcoat

Pets, parties, prams... your wood floor doesn’t stand a chance without proper protection. OmniStrong is the third and final coat that gives your floor high resistance to scratches, spills, and harsh cleaning products. If you’ve got dogs, cats, or busy foot traffic, your floor will wear faster than usual. This topcoat gives it the best chance of holding up, keeping your finish looking fresh for longer. 

OmniStrong is a two component water based polyurethane finish. It hardens into a tough, clear film that seals in your base coats and adds long term durability.

Available Sizes

• 1.1 litre (1 litre lacquer with 0.1 litre hardener), covers up to 18 square metres, 2.5l OmniTone should cover the previous 2/3 coats

• 2.2 litre (2 litre lacquer with 0.2 litre hardener), covers up to 30 to 35 square metres, could be used in conjunction with 5L OmniTone or if you would simply like to roll more tough top coats.

How to Use

1. Mix both components thoroughly in the container, put lid on and shake well
2. Pour and stir until fully blended and uniform
3. Apply with a microfibre roller as your third and final coat once your base coats are fully dry

 Why Use It

• High resistance to scratches and chemical wear

• Designed for homes with pets, children, and heavy traffic

• Locks in and strengthens your existing finish

• Crystal clear Extra Matt or Matt Slight Sheen result

• Smooth and even flow for easy application

Use OmniStrong as the final step over a two coat water based system for the best long term performance.

Drying Times & Safety Information

OmniStrong – Drying & Safety Guidance

Drying times (20 °C, normal humidity, good airflow):

• Pot life once mixed: approx. 3–4 hours — only mix what you can use in this period
• Dust-free: 30–45 minutes
• Ready to recoat: 2–3 hours (in good conditions, 1 hour may be sufficient)
• Light foot traffic: 2–3 hours (socks only)
• Furniture back: 24–36 hours (lift, don’t drag)
• Rugs and heavy items: 3–5 days
• Full cure & chemical resistance: approx. 5–7 days

Application notes:

• Always mix thoroughly with the supplied hardener in the correct ratio.
• Apply thin, even coats using recommended applicators.
• Maintain good airflow but avoid draughts and direct heat.
• If more than 24 hours passes before recoating, lightly abrade the surface and remove dust before applying the next coat.

When sanding or applying wood finishes, always work in a well-ventilated area. A respirator or suitable dust mask is strongly advised to protect against fine wood dust and vapour inhalation. Wear gloves and eye protection where appropriate, and wash hands thoroughly after use. Keep products out of reach of children.